Process:

•Inserting FMA Component with the EPU-Object Inserter.
 

Requirements:

•Determining the Planning Direction

•Specifying Track Identifiers for Section Tracks

 
Description:
 
The FMA Component is a Dot-like PSO and is positioned at the boundaries of a track clearance section. When an FMA Component is created with the EPU Object Inserter, the FMA Component type is preset to 'Achszaehlpunkt'.
 
There are currently two different ways of inserting this object into the drawing. The detailed description for inserting FMA Components via the ribbon can be found under Track Clearance Planning, Step 5.

Information on the formulation of the object in the PlanPro glossary can be found on the page Planning Track Clearance under the description.

 
Procedure:
 

1.To Insert an FMA component, use the EPU-Object Inserter function. Select the Object type 'FMA Component'.

Command Line: PRS_EPU_EINF

Ribbon: ProSig EPU -> Equipment SCT -> EPU-Object Inserter

Illus.: Selection of object type FMA Component in EPU Object Inserter

2.With the button 'Paste' a new object 'FMA component' can be inserted into the drawing. A point on the topological edge or an object (an existing signal or PZB element) is to be selected as reference point, over which the boundary of a track clearence section can be defined. The general description for the Insertion of Dot-like PSO must be observed here. Information on inserting FMA components can also be found under Track Clearance Planning, Step 5.
 
 

3.The FMA component is a Dot-like PSO. When creating an FMA component with the EPU Object Inserter, the type of FMA component used is 'Achszaehlpunkt'. The object is therefore stored on the layer PRS-FMA-COMPONENT-ACHSZAEHLPUNKT.
 

Illus.: FMA Component after creation with the EPU Object Inserter in the drawing
 
 

4.The allocation of the object attributes is to be carried out as described under Track Clearance Planning, Step 7.